The role of microbial electrogenesis in regulating methane and nitrous oxide emissions from constructed wetland-microbial fuel cell

This study assesses a sustainable solution to greenhouse gases (GHGs) mitigation using constructed wetland-microbial fuel cells (CW-MFC). Roots of wetland plant Acorus Calamus L. are placed in biological anode to better enable anode microorganisms to obtain rhizosphere secretion for power improvement. Three selected cathode materials have a large difference in GHG emissions, and among them, carbon fiber felt (CFF) shows the lowest emissions of methane and nitrous oxide, which are 0.77 ± 0.04 mg/(m²·h) and 130.78 ± 13.08 μg/(m²·h), respectively. The CFF CW-MFC achieves the maximum power density of 2.99 W/m³. As the influent pH value is adjusted from acidic to alkaline, the GHGs emissions are reduced. The addition of Ni inhibits GHGs emission but decreases the electricity, the power density is reduced to 1.09 W/m³, and the methane and nitrous oxide emission fluxes decline to 0.20 ± 0.04 mg/(m²·h) and 15.49 ± 1.86 μg/(m²·h), respectively. Low C/N ratio reduces methane emission, while high C/N ratio effectively inhibits nitrous oxide emission. At the influent pH 8 and C/N = 5:1, the methane emission flux is approximately 10.60 ± 0.27 mg/(m²·h), and the nitrous oxide emission flux is only 10.90 ± 1.10 μg/(m²·h). Based on the above experimental results by controlling variable factors, it is proposed that CW-MFC offers an environment-friendly solution to regulate GHG emissions.     

Characteristic tryptic peptides and gelling properties of porcine skin gelatin affected by thermal action

Thermal action in extraction process had effects on characteristic tryptic peptides identification and gelling properties of porcine gelatin. SDS-PAGE, HPLC-LTQ/Orbitrap high-resolution mass spectrometry, texture analyser and rheometer were used to evaluate collagen depolymerisation degree, characteristic tryptic peptides and gelling properties of gelatins prepared in various thermal actions. Results showed that with increasing temperature and time, depolymerisation degree enlarged, while gel strength, gelling and melting temperature decreased. Mass spectra showed that 47 and 49 common characteristic tryptic peptides were identified in gelatins extracted at 50 °C and 100 °C with various times, respectively. Moreover, 34 common characteristic tryptic peptides were identified in all gelatin samples. Further comparison between this work and our previous investigations yielded 20 common characteristic tryptic peptides, which stably exist in various thermal actions. These common characteristic tryptic peptides may be very helpful for the accurate authentication of porcine gelatin.     

Vapor linker exchange of partially amorphous metal–organic framework membranes for ultra-selective gas separation

Metal–organic framework (MOF) membranes are promising for efficient separation applications. However, the uncontrollable pathways at atomic level impede the further development of these membranes for molecular separation. Herein we show that vapor linker exchange can induce partial amorphization of MOF membranes and then reduce their transport pathways for precisely molecular sieving. Through exchanging MOF linkers by incoming ones with similar topology but higher acidity, the resulted metal-linker bonds with lower strength cause the transformation of MOF membranes from order to disorder/amorphous. The linker exchange and partial amorphization can narrow intrinsic apertures and conglutinate grain boundary/crack defects of membranes. Because of the formation of ultra-microporous amorphous phase, the MOF composite membrane shows competitive H₂/CO₂ selectivity up to 2400, which is about two orders of magnitude higher than that of conventional MOF membranes, accompanied by high H₂ permeance of 13.4 × 10⁻⁸ mol m⁻² s⁻¹ Pa⁻¹ and good reproducibility and stability.     

Hydrangea like composite catalysts of ultrathin Mo2S3 nanosheets assembled on N,S-dual-doped graphitic biocarbon spheres with highly electrocatalytic activity for HER

Water electrolysis is the most clean and high-efficiency technology for production of hydrogen, an ultimate clean energy in future. Highly efficient non-noble electrocatalysts for hydrogen evolution reaction (HER) are desirable for large scale production of hydrogen by water electrolysis. Especially, exposing as many active sites as possible is a vital way to improve activities of the catalysts. Herein, a series of new hydrangea like composite catalysts of ultrathin Mo₂S₃ nanosheets assembled uprightly and interlacedly on N, S-dual-doped graphitic biocarbon spheres were facilely prepared. The unique structure endowed the catalysts highly exposed edge active sites and prominently high activities for HER. Especially, the optimized catalyst Mo₂S₃/NSCS-50 exhibited as low as 106 mV of overpotential at 10 mA/cm² (denoted as ?₁₀). The catalyst also showed low Tafel slope of 53 mV/dec, low electron transfer resistance of 34 Ω and high stability evidenced by the result that the current density only attenuated 11.7% after 10 h i-t test. The catalyst has shown broad prospect for commercial application in water electrolysis.     

Tri-reformer with O2 side-stream distribution for syngas production

Methane tri-reforming combines steam reforming, dry reforming and partial oxidation of methane in a single reactor. The heat generated by the exothermic partial oxidation of methane can be used to supply the energy for the other two endothermic reactions (dry and steam reforming of methane). The thermoneutral condition allows the use of a tri-reformer with a simpler reactor structure since no external heat supply is necessary. Thermodynamic analysis of the thermoneutral reactor was performed using Gibbs free energy minimization approach. Conventional tri-reformers have heat and mass management problems. We developed a novel tri-reformer concept that utilizes proper distribution of O₂ gas to the reactor to address the problems. The optimization of the proposed reactor was performed with the objective function of minimizing total annual cost. Maintaining the peak temperatures by adjusting the O₂ flow rate at the distribution point along the reactor was shown to provide good load flexibility for the change in methane flow rate.     

Parameter study for dimensioning of a PV optimized hydrogen supply plant

Green hydrogen produced from intermittent renewable energy sources is a key component on the way to a carbon neutral planet. In order to achieve the most sustainable, efficient and cost-effective solutions, it is necessary to match the dimensioning of the renewable energy source, the capacity of the hydrogen production and the size of the hydrogen storage to the hydrogen demand of the application.For optimized dimensioning of a PV powered hydrogen production system, fulfilling a specific hydrogen demand, a detailed plant simulation model has been developed. In this study the model was used to conduct a parameter study to optimize a plant that should serve 5 hydrogen fuel cell buses with a daily hydrogen demand of 90 kg overall with photovoltaics (PV) as renewable energy source. Furthermore, the influence of the parameters PV system size, electrolyser capacity and hydrogen storage size on the hydrogen production costs and other key indicators is investigated. The plant primarily uses the PV produced energy but can also use grid energy for production.The results show that the most cost-efficient design primarily depends on the grid electricity price that is available to supplement the PV system if necessary. Higher grid electricity prices make it economically sensible to invest into higher hydrogen production and storage capacity. For a grid electricity price of 200 €/MWh the most cost-efficient design was found to be a plant with a 2000 kWp PV system, an electrolyser with 360 kW capacity and a hydrogen storage of 575 kg.     

Phenolic profiling reveals the metabolite basis of flesh colour and fresh-cut browning in apple fruit

Flesh colour, which is affected by cultivars and browning, can largely impact consumer acceptance in fresh-cut apples. The study profiled phenolic metabolites from apple flesh of twenty-three cultivars by widely targeted metabolomics. Comparison among white- and yellow-fleshed cultivars showed fifteen phenolics, mainly quercetin 3-O-glucoside, hyperoside, hesperetin 5-O-glucoside and cymaroside, in white-fleshed apples were significantly higher than those in yellow-fleshed apples. It may indicate a metabolite basis of yellow and white flesh colour, and better potential nutrition in white-fleshed apples. In addition, ten phenolic metabolites including five cyanidin glycosides showed significant differences between the highest and the lowest browning groups, indicating them may be crucial in browning of fresh-cut apple. This work elucidates the differences of phenolic profiles among apple cultivars with different flesh colour and provides useful data to evaluate the suitability of apple for fresh-cut processing.     

Assessment of technological attributes of autochthonous starter cultures in Turkish dry fermented sausage (sucuk)

The study aims to evaluate the technological properties of autochthonous strains (Lactobacillus sakei S15, Lactobacillus plantarum S24, L. plantarum S91, Pediococcus pentosaceus S128b and Staphylococcus carnosus G109) in Turkish dry fermented sausage (sucuk). After 24 h of fermentaPtion, all lactic acid bacteria strains reduced the pH to below 5.0, while the pH in the control group was above 5.3. The number of lactic acid bacteria strains reached 10⁸–10⁹ cfu g⁻¹ during fermentation. Staphylococcus carnosus G109 remained at the inoculation level of 10⁶ cfu g⁻¹ during ripening. Lactobacillus sakei S15 as mono-culture showed higher TBARS values compared to other strains. The control group had the lowest L* value and autochthonous strains caused no significant difference for a* value. According to principal component analysis results, most volatile compounds were positively correlated with the group containing only L. sakei S15.